An ignition cylinder, or ignition switch as it is sometimes referred to, is a small, but critical part of any vehicle. This small, cylindrical piece of hardware sits on the right side of a vehicle’s steering wheel and is the encasing to the slot where you insert your car key. An ignition cylinder must work properly in order for your vehicle to start. When you insert your key into the cylinder, if something is not working or properly in place, the vehicle will not receive power and the engine will not start. Even though an ignition cylinder is small, it can cause major problems. There are a few indicators that will clue in vehicle owners to a possible faulty ignition cylinder. Below you will find the most common symptoms of an ignition cylinder that is broken or in need of repair.
This is the most common indicator that your vehicle’s ignition cylinder needs to be replaced. Keep in mind that your vehicle’s ignition cylinder is used every single time you start and stop your vehicle. Over time, the ignition cylinder may wear out and not be able to properly turn anymore, thus causing the vehicle to not start.
Your car in this instance may also start but then stall. Again, this could be because the ignition cylinder has been worn down and is unable to hold the key in place. Stalling and then stopping usually indicates that the cylinder is worn and is slipping out of place, causing the key to loosen and stop the car.
Your Vehicle’s Electrical System Will Not Turn On
Usually with one turn of your car key in the cylinder, you can get the car’s electrical panels to light up without necessarily turning on the gas. If you have attempted to turn on your vehicle and are not even seeing the electrical panel light up, this could indicate that the cylinder should be replaced or repaired.
Your Key will Not Turn in the Cylinder or will Not Fit into the Cylinder
There is also the possibility that there is something jamming or blocking the entrance to the ignition cylinder. If you notice the key will not go in all the way or gets jammed in a certain way, it could be that there is something in the slot that is causing the issue. If you do notice that there is something blocking the cylinder slot or there is some other interference, do not try to pull it out. This could cause even more damage to your ignition cylinder and makes things worse or costlier in the end. Be sure you speak with a locksmith before attempting to do any sort of deeper investigation into your ignition cylinder in this case, or in the ones listed above. Ignition cylinders are meant to be tricky to get to for good reason. They are housed in the steering panel in order to deter thieves and make the car much more difficult to tamper with and steal. A professional locksmith will have the right tools necessary to repair your cylinder and will also have experience with various vehicle makes and models or types of ignition cylinders.
Read more on: Common Ignition Cylinder Problems and Solutions
No comments:
Post a Comment